TOPIC: crankshaft spline

crankshaft spline 5 years 10 months ago #138044

propnut Offline Senior Boarder Posts: 198 Karma: 2 Thank you received: 0	hi, i recently bought a boat that came with a 90hp inline 6 that the lower unit locked up and stripped the driveshaft and crankshaft splines. is there any way to fix the crankshaft spline other than pulling the powerhead apart and replacing crankshaft? thanks Check this box to be notified of replies to this topic. Note: BBcode and smileys are still usable.
	Please Log in or Create an account to join the conversation.

crankshaft spline 5 years 10 months ago #138045

dave bernard Offline Platinum Boarder Posts: 1470 Karma: 95 Thank you received: 30	dependable NO. Check this box to be notified of replies to this topic. Note: BBcode and smileys are still usable.
	Please Log in or Create an account to join the conversation.

crankshaft spline 5 years 10 months ago #138048

propnut Offline Senior Boarder Posts: 198 Karma: 2 Thank you received: 0	i didn't think so, just figured i would ask, to bad. the kid i bought it from said the powerhead was rebuilt last winter. thanks Check this box to be notified of replies to this topic. Note: BBcode and smileys are still usable.
	Please Log in or Create an account to join the conversation.

crankshaft spline 5 years 10 months ago #138049

dave bernard Offline Platinum Boarder Posts: 1470 Karma: 95 Thank you received: 30	1 914 310 7086. Dave. Check this box to be notified of replies to this topic. Note: BBcode and smileys are still usable.
	Please Log in or Create an account to join the conversation.

crankshaft spline 5 years 10 months ago #138067

ed-mc
Offline
Platinum Boarder
Posts: 1408
Karma: 232
Thank you received: 115

If it's a 99-c.i. engine, any 99-cube (non-racing) crankshaft will work. Just change the reed stops or swap reed blocks to the donor crank.

If it's a 90 c.i. there are a few different styles, '64-older and '65-'70. The big distinction there is whether the upper and lower crankshaft ball bearings are pressed into the bearing caps and a slip-fit on the crank (older), or pressed onto the crank and a slip-fit into the bearing blocks (later-models).

HTH...........ed