TOPIC: crosby Logo

Does anyone out there have a Crosby hull side logo that we would make a silicone mold of and then epoxy or aluminum cast some repro's. My initial thoughts were to use a chopped glass strand filled epoxy for this. Aluminum could be done though. I'd be happy to pay for the shipping and insurance on it.
I sure hope someone has one.
Cheers,
Paul

Ok, no luck there. Is anyone willing to provide us with a fairly close up picture of the Crosby logo on a boat??
Paul

I was looking at the boat deck hardware on ebay yesterday and I think I seen a pair on there. It may have been in a lot of different pieces.

if i remember correctly i came across a website that was making reproduction decals for old boats if i can find the website i will post it here

ahh just came to me www.vinylapproach.com you can check there they may have what youre looking for

Frank Fenninger at This email address is being protected from spambots. You need JavaScript enabled to view it.

I have an original (plastic)...

I have a nice set of repros I bought years ago from meone here on the site.

Send me an e-mail. Thanks!

Shipster,STN19,Robert-Lorigan thanks for your suggestions I checked out a couple of them and there are options there that could work.

CrosbySeaquin, I have sent an e-mail and am very grateful to hear from you.
Paul