TOPIC: Looking for a new Pulley Helm

Looking for a new Pulley Helm 12 years 4 months ago #61714

tey1967
Topic Author
Offline
Contributing Member
Posts: 161
Karma: 7
Thank you received: 0

I am tired of the helm on my Glastron. It has a big nut that screws on the shaft to keep it tight to the dash. I can't seem to tighten it very well and now it is slopping around on the dash scratching the paint. I am looking for one that can bolt on. Any ideas? Does anyone make a new one? I am not willing to convert to tele type. How about a source for a used one? Donor boat in Michigan?

Thanks!

Please Log in or Create an account to join the conversation.

Re:Looking for a new Pulley Helm 12 years 4 months ago #61770

gdanderson
Offline
Contributing Member
Posts: 155
Karma: 33
Thank you received: 0

I had the same problem on mine. Ended up removing the nut and placing three large washers on the shaft then reinstalling the nut. That gave me a fresh set of threads for the nut to grab on to. Turned out the threads on the shaft were very badly worn. Of course that means you have to remove the steering wheel and the steering wheel shaft.

Greg Anderson
Wisconsin

Please Log in or Create an account to join the conversation.

Re:Looking for a new Pulley Helm 12 years 4 months ago #61943

tey1967 Topic Author Offline Contributing Member Posts: 161 Karma: 7 Thank you received: 0	Good call! I will try that! Check this box to be notified of replies to this topic. Note: BBcode and smileys are still usable.
	Please Log in or Create an account to join the conversation.